Connecting the cooking panel by yourself

click fraud protection

You have a need to purchase a hob. After purchase, the connection becomes one of the problems. First of all, you should carefully read the manufacturer's instructions if you are connecting, for example, a Bosch hob or other brand. The connection of the electric hob to the itself must first be started by installing an earthed socket. In addition, it is necessary to have a clamp-adapter and a cable with a cross-section up to 3 mm. Both the cable and the clip need to be purchased separately.

Contents

  1. Power
  2. Wiring plan for the electric hob
  3. Video connecting the hob

First turn the hob and remove the cover of the connector. Using a knife, we clean the ends of the cable. After that it is necessary to determine where the mass, zero and phase are. To do this, you must prepare a tester in advance.

The Bosch brand is very popular with consumers. The qualitative technique in terms of connection and operation is simple and understandable. Here everything is thought out, that's why the installation of equipment and connection does not require a lot of mental strain. Bolts are structurally so arranged that they do not require any terminals. Just wind the bolt a half turn, and then twist it. After carrying out all manipulations, twist the contact cover.

That seems to be all about the issue of how to connect the cooking hob. It should also be borne in mind that if you buy a connector separately, it will certainly be manufactured by the PRC.Typically, such connectors are of poor quality and are not properly assembled. Fastening of such a connector of poor quality.

Power

When connecting the hob, special attention should be paid to the electrical power. After a short period of time, the plate heats up, which is very convenient. However, everything is paid for. Due to the high heating rate, the electric power consumption is quite large. Sometimes it comes to 7 kW .Therefore, higher demands are placed on the cable. Especially this applies to the feed contacts of the hob. In order to minimize contacts and reduce the possibility of a short circuit, power can be applied directly to the terminals of the surface. The main requirement for a cable is copper with a diameter of at least 4 mm.

Wiring plan for the electric hob

If the plug is ready for connection, it is not difficult to connect the tile yourself. It is much more difficult to understand the switching of wires suitable to the outlet. For example, from the cooking surface four wires go, while in the wall there are only three.thus it turns out that the cooking surface has two phases, and the apartment has only one.

It is necessary to wire the black and brown surfaces together. Then twisted strands must be connected to the phase of the apartment. Usually this wire is white. Ground wires will remain free in this case.

It is highly recommended to call electricians-professionals if you are not confident in your abilities! After all, working with an electrician is dangerous for health and life!

Video connection of the hob

For clarity, we offer a video lesson for connecting the hob.

instagram viewer