Staples for the construction stapler - modifications and gauges
Tool for clogging staples and small nails - a teapot, popularly known as a stapler, enjoys considerable success with both professional builders and home masters. Large staples for a construction stapler are extremely convenient for two reasons. First, immediately fastens at two points, which is much stronger than if you use one nail for the same purpose. Secondly, the cross member grips the fastened part more reliably than the cap of the same nail.
Caliber of special nails shot with a stapler, usually small - length up to 32, and thickness within 1.6 millimeters, hats( rather cross-pieces) are also larger in size.
Modifications of staples are very different. For example, U-shaped, similar to clerical, but more powerful, depending on the caliber are used when installing on a wooden or even concrete surface of various soft materials, from fabric to plastic siding. To fix the cable of different diameters, rounded U-shaped staples are used. The construction of a stapler is such that the staple cartridge can be inserted into the magazine either horizontally or vertically, in any case, the feed will only be carried out along the magazine channel.
Construction stapler: instruction for use
Professional staplers operate not only from a spring driven by a tight trigger lever. There are also much more serious tools with an electric mechanism, powered from a power cable or battery. The first option implies almost continuous operation throughout the day, the second requires either an electrical system or regular recharging. Models with batteries give full autonomy, which is sometimes extremely necessary .To start using a construction stapler, the instruction can be read only once, after which you can start working, but caution to exercise will not hurt.
The fact is that any teker has practically no fuse, which does not allow the charge to fly out, whether it be a clamp or a nail, without stopping in a hard surface. The only exceptions are the so-called automatic hammers, staples and nails which are driven in by a tool on the surface( accuracy is not guaranteed).Turning the stapler of the usual push action towards the helper or your own arm or leg, you can cause serious injury.
Usually, to make a shot, you need to put some effort, accidental operation is almost impossible, but while the tool is not used, it is better to put it on a special bracket-lock. Otherwise, there is nothing tricky about using a construction stapler. Simply mark the line on which you will drive the fasteners, and tightly press the tool on it to avoid displacement due to the inevitable recoil. To pull out the clamp or a teker nail, it is not a nail driver, but a special tool resembling ticks.
How to charge a construction stapler: types of
shops As mentioned above, you can charge the tapes by placing the cassette horizontally or vertically, depending on the model of the instrument. This applies to the staples and nails, for these two fairly different consumables used the same store, and the piercing is not necessary. The main thing, immediately ask the seller how to fill the construction stapler, even if it shows, and not once.
Staples and nails are always glued into bundles that can contain a different number of "charges", depending on the caliber of .So, the store can hold up to 80 staples and up to 100 nails, in the package can be from 1000 to 5000 pieces. Staples are inserted into the store easily, it's enough to just lay them in the gutter, but how to charge the stapler with nails is another conversation, everything is different.
First of all, after you opened the store, pay attention to the firing pin. Where there should be a nail, there is a special thickening, usually it is positioned to the right or left, but there are also symmetrical pins. If the thickening is only on one side, it is along the same wall of the gutter that the nail is stacked, then clamped with a feeding mechanism. If the firing is symmetrical, the nails can be placed along any wall.