Advantages of chandelier with remote control
Such lighting devices have many advantages.
- Low power consumption.
- Good lighting ability.
- Stylish design.
- High level of security.
- Reliability.
- Ease of operation.
Remote control of the chandelier provides a simple and comfortable operation of the lighting device. In addition, these chandeliers are resistant to frequent on and off, have a long service life.
Chandeliers with remote control - this is an excellent solution for modern apartments, spacious houses, as well as many public institutions.
How to repair chandeliers with remote control?
This chandelier usually has 9 incandescent lamps on 3 control channels. The cause of the breakdown of the device can serve as voltage drops in the network and large loads on the lamp. Usually the control unit goes out of action.
To repair a chandelier with remote control, it is necessary to replace the control unit with a new one, it is fixed to the top panel of the chandelier. In the bundle of the new unit there is always a double-sided adhesive tape.
It is not difficult to disassemble and assemble the device, as the scheme of its operation is indicated in the instruction. It is important, during repair, halogen lamps should not be touched by hands, only with gloves.
Another reason for failure is the failure of the LED.They break down usually by a batch, at once for 5-10 pieces, therefore at repair it is better to replace at once all. Changing LEDs is easy, they are inserted into the connector. However, one can not confuse the polarity of even one diode, since in this case the entire circuit will fail. Correction of more complex breakdowns is recommended to be entrusted to specialists.
Principle of operation and device of a chandelier with remote control
Despite the variety of designs, almost all lighting devices are assembled from similar electronic units. The main components are:
- Lamp with halogen lamps.
- Radio controlled relay.
- Control panel.
- LED Downlight.
Lamps can be as soon as with LEDs, and combined - LED and halogen. The relay provides an independent inclusion of a light bulb.
You can control the chandelier with remote control by having a relay unit. It is powered by a 220V network and consists usually of two relays. Bad block sealing can cause a halogen lamp not working.
The device is very simple - it has a board, two transistors and a chip that encodes and transmits commands. There are only 4 buttons on the control panel.
To power halogen lamps, a step-down transformer is used. The installed bulbs are easily checked for service by a multimeter. For each step-down transformer, there are 5 halogen lamps with a power of 20 W each, that is, both transformers produce 100 watts each.
The lamp is powered from the mains, to reduce the mains voltage used on the power supplies on the ballast capacitor. However, chandeliers with a quenching capacitor have lower reliability.
Chandeliers with remote control, the scheme of which is presented in the instructions for the product, have a fairly simple device and are easily repaired. Partly this is one of the reasons for their growing popularity - the lamps are stylish, comfortable, simple and modern.
