Video for repairing an apartment with your own hands - how to properly install the door yourself.
To begin with, it is necessary to dismantle the old doors, and the opening to clear of construction debris( old cement, etc.).Then a new door frame is assembled. Vertical racks are measured in height and cut off with a chair to the desired size, and the horizontal bar is delivered in the size of the door leaf. The file must be treated with rubbing surfaces. For reliable fixing in the corner connection of the box screws are screwed. Place under the loop is marked by the place of the hinges on the door leaf. The horizontal rack is applied to the door so that there is a gap of 3 mm between the door and the horizontal crossbar of the box. When you want to install an interior door entrance or heavy, then the doors must be hung on three loops, and the interior doors by two. Verifies the verticality of the walls of the doorway and installs the assembled box. Wooden wedges fix the box of the interior door and level it to verify its verticality. Vertical racks are attached to the wall with large screws and dowels. The remaining holes are closed with special caps.
On the door leaf the markings are made for loops. From above and from below measure on 200 mm, put a loop and lead around with a pencil. The place under the hinge is given out using a chisel and a hammer. All open surfaces( for hinges or locks) must be treated with lacquer. In the places under the screws, holes are drilled, then loops are screwed. After this, markings are made at the location of the lock for depth and width. The lock is usually installed at a height of 800 mm to 1100 mm from the bottom edge of the door. With the help of a milling cutter hole is milled. If the hole is drilled, then it is better to do this not with one, but with both sides alternately. After correct installation of the lock, the interior door can be installed. Produce hanging the door leaf on the hinges.
The foam must be filled with a space between the box and the wall. Foam has the property of greatly expanding and at the same time creating pressure. Therefore, the door frame is strengthened by spacers. The foam dries from 4 hours to 24 hours, depending on the composition.
The last stage is the installation of clysters. They close the gap between the box and the wall. The platens are severely cut at 45 degrees. To the box are nailed with small studs with flattened hats or absolutely without hats. The distance between the nails should be 100 mm - 150 mm.
Video how to install the door yourself
Specialists of "Superstroy" show the whole process, how to install the interior door with your own hands and the execution of the lock of the lock.
Now you can install the interior door yourself, without any problems and extra costs, on video instructions. Stay on our website - repairing the apartments on your own and repairing will be done correctly.
Author Kurochkina Svetlana Sergeevna
