Today almost everyone has a cell phone. I have one, and not one, but two. And then there are two "lovers" of these phones, not the age of developed and curious. Usually, when I get home, I clean the phones so that they can not reach them. But if you need to put the phone on charge, then the difficulties begin. Certainly someone is striving to step on or to sit on the phone. You can, of course, buy a stand for the phone.
But, first, than spending money and time searching for a stand, it's better to do it yourself, and, moreover, it's pretty quick. Secondly, I would like the stand with the phone also to be outside the "reach zone".In the sense that children do not "get" no phone, nor, in the end, me and my wife. And thirdly, her "magic" words "Well, you can do everything? !" inspired me with enthusiasm.
Making a stand for mobile
On the Internet, there are many different tips on this topic. As they say, who is on that much. Therefore, I, after carefully reviewing everything, made it as convenient for me. The stand decided to make a "high-rise" to be at the level of the outlet and the children could not get to it. As a basis, I took a bottle from the shampoo of the phytotherapeutic "Clean Line".Focused on the most out of our three cellular( two my and one wife).The bottle has a width of just over 7 cm, and a height of 20 cm, so it turned out exactly what you need.
I immediately cut the vial. Then the resulting case carefully washed from the remnants of shampoo and dried. Then - the markup. Attached the phone to the resulting case and noted the height of the front wall. I made it so that you could see one third of the phone's case. But for the sample took the smallest mobile phone - his wife.
With a thin felt-tip pen, a cut line was drawn in front and at the sides. Sideways to the middle( width).It remains only to take a knife to cut the paper and gently cut off the excess. It turned out that the front wall was "liquidated" by more than half the height of the case.
There is one nuance here - the power cable to the phone is connected on the side. Therefore, also from one side of the case I made a wider neckline and slightly lengthened it. I calculated so that the phone with the connected cable fit well in the stand. The top of the back wall of the case I neatly rounded with large scissors.
Now - the place to install the charger. The idea is this: the fork of the charger must "pierce" the case( the back wall) at the top. And then, together with the case and the phone in it, the charger is plugged into the outlet. I marked out the holes for the holes so that the charger pins easily fit into the wall of the case. Then I took the bit by 3.6 mm( which was at hand) and drilled the holes, that's all, it's ready.
It remains only to process the edges of the resulting support - suspension and holes. I did this with a small file and sandpaper. My wife began to think out what to put on the stand for beauty. But on this issue for advice - to her. And I've already done my job, and a convenient mobile phone stand is ready.
On the video you can see one of the options for making a stand:
