Most often in the suburban towns there is undervoltage in mains
Increasing the voltage in the network holiday villages happens rarely, nevertheless it can cause equipment damage or failure of the individual blocks and elements.
If you will be in the country only from case to case, it will not protect appliances from possible sharp voltage drop and, as a consequence, the release of her failure.
The only solution in this case would be to purchase and install a suitable voltage regulator for questioning.
Voltage stabilizer for heating Teplocom ST-555
Voltage regulator 220 for questioning: what to choose (single-phase or three-phase)
Moments that should be taken into account, going to buy household voltage regulator for home and garden:
- power system at home - single or three phase;
- total available electrical power;
- as planned stabilizer will be resistant to changes in voltage oscillations on the reaction rate and tolerability overloads;
- possibility of rectifier in a wide temperature range;
- cost of the device and its reliability.
Wiring phase voltage stabilizer for electrical
Usually in suburban homes and cottages there are single-phase power supply system, but it happens that the owners provide a three-phase power supply for the use of a special electrical equipment. In accordance with the power system selected and Surge ProtectorsIf the house cable contains two or three wires - requires a single-phase equalizer, if there are four wires - required three-phase rectifier. In the case of a three-phase system, if you do not plan to use three-phase equipment, possible to connect three-phase stabilizers.
Related article:
|
Selection of single-phase voltage stabilizer to give General Settings
Before proceeding to the analysis of various stabilizers models, you need to plan how it will work Rectifier: whether it will be used for the entire system or connected to some electrical equipment.
Wiring single-phase voltage stabilizer for electrical
The choice of stabilizer power
To determine the capacity of the planned stabilizer, you must know the required power rating of the circuit breaker on the panel. If the machine is designed for 40A, this figure should be multiplied by the existing voltage of 220V. The result is a 8.8 kW. This figure and should be guided in choosing the power rectifier. In addition, it is recommended to choose the stabilizer with some reserve capacity (approximately 20%). So, in our case, you should opt for a voltage stabilizer to give 10 kW.
Useful advice! The effectiveness of the stabilizer is dependent on the deflection voltage. Too low a voltage will greatly contribute to less efficiency of the device. Therefore, you should choose the regulator to order more of the power of the estimated amount of power devices.
To select the acquired power stabilizer is necessary to determine the nominal power circuit breaker panel
Of course, powerful enough rectifiers models are highly valued. For a more accurate calculation can be summarized power of all full and giving electrical equipment. But do not forget that the starting power technology, which has in its electrical device will increase 3-5 times. These figures must be considered when determining the capacity of the plant.
It is also possible to connect only some through stabilizer technique at your discretion, for example, only a refrigerator and air conditioning. Then it will be enough to acquire equalizer voltage 3kW. Such a 220V voltage regulator to give the price will be much lower.
To connect one or two appliances can be used with the rectifier 3 kW
Selection of the stabilizer on the main characteristics
Criteria for selection of the voltage equalizer for holiday houses, based on the fact that most holiday house is used occasionally. As a consequence, the country house is not heated in the winter and electricity in such areas known to be substandard. In this case, the important characteristics are such devices as operability at low temperatures and the ability to stabilize the voltage in a wide range.
Stabilizers for the cottages must have sufficient input voltage range, especially for the lower limit. This is necessary to ensure that under-voltage or turn on high power equipment, other equipment in the house is not disconnected. Furthermore, the operation of household appliances in summer conditions required eliminator capable of operating in the overload mode, and low temperature, and is continuously adjustable operating silently. Because it is often suburban houses are equipped with different types of equipment, including precision electronically controlled, requiring high-quality protection.
Using a voltage regulator in a country house heating system
To choose the right regulator, you must see to it that what is the maximum and minimum supply voltage. This will determine how to convert a range you have to install the device.
Useful advice! For daily measurement on the network voltage fluctuation range using a voltmeter or tonkoizmeritelnye mites.
You should also pay attention to when buying on the accuracy of the voltage equalization. If you offer to buy a device with an accuracy of correction of 10%, then this figure is not one of the best and not always able to protect the high-precision technology. Should opt for models with an accuracy of 1% to 5%.
Voltmeter - a device for measuring the electrical voltage
It plays an important role and the duration of the voltage drop. In this case, the stabilizer must have the ability to work under overload conditions.
If you plan to use the rectifier in the winter, the model should be chosen to function at low temperatures.
Features installation of stabilizers
Thinking over what to choose 220V voltage stabilizer for villas and cottages, you should pay attention to the ways of the installed unit. Manufacturers offer a way to install floor and wall mounting option. Given that the country houses, as a rule, do not differ weighty dimensions and square footage Square strictly divided, the ideal is to install wall-mounted voltage converter.
Fixed outdoor voltage regulator to give
Wall rectifiers have a modern design, do not clutter up the room and have a number of qualities for the protection of electrical engineering in the country.
Wall voltage converters installed on site after the meter. All that is required for its installation - fixed to the wall mounting plate and hang it on the device itself.
Wall surface stabilizers are reliable in operation, their use in the country to be sure allow energy saving household appliances, electric boilers, pumps and power tools. An important feature wall analogues is that they can be mounted in the back unheated rooms and operate at different temperature conditions, which is especially convenient for country houses and cottages.
SVEN AVR PRO LCD 5000 voltage regulator Wall
What better voltage regulators for questioning: reviews of devices
Main characteristics and cost of the stabilizer depends on the type and appliance device. When you select should first take into account the individual needs. On the market there are three types of electric rectifiers, the distinctive characteristics of which are given below.
Relay devices. The choice of stabilizer to the country for many by the cost of the device. From this point of view - the relay rectifier voltage-to-date version. This device has a good leveling speed and sufficient range of input voltage. User reviews indicate a long life relay stabilizers, their ability to withstand long-term overload (over 100%). Disadvantages include error output indices to 7%.
The operating principle of the relay voltage regulator
Useful advice! If your house is in the country has a high-precision equipment that is sensitive to small voltage fluctuations, the stabilizer should be selected with an accuracy of less than 3% alignment.
Electromechanical stabilizers. Such devices are composed of 2-3 transformer has adequate power and reasonable price. The advantages of these devices users include: accurate output voltage performance, smooth control, a small sensitivity to vibrations, noise-free operation. Electromechanical rectifiers transferred brief overload of up to 200%. To this type include stabilizers and electrodynamic transducers, capable of operating at low low temperatures to -20 ° C and to withstand a short-term overload (2 min) up to 200%, but their price significantly higher.
Using a voltage stabilizer to give ensure stable operation of electrical equipment and appliances
electromagnetic rectifiers. These devices are faultless for country houses located in areas with harsh climatic conditions. They can easily cope with the functions at low temperatures (up to -40 ° C) and high (+ 50 ° C) temperatures, are endowed with high speed stabilization. From the reviews it is known that an electromagnetic transducer is noisy, so they will be important to find a place outside the living room. Moreover, they are sensitive to changes in frequency and load reduction of 15% is stopped its operation. This should be considered when selecting holiday villages, where surges are quite large.
The correct choice of voltage stabilizer to give guaranteed to provide uninterrupted power to electrical equipment and extend the life of existing equipment.
