How to cover a siding house.
If the work on the facade cladding - siding - is done beautifully, you will not pass indifferently past the house. The house will no longer need to be repainted or processed by various means. Siding will not peel off, peel off, will not cover with moss and will not rot. Cope with the facade of any. Only experience of home tools is needed. Everything is done easily and very quickly. Elementarity in the paneling made the siding interesting and convenient. Now let's figure out how to cover a house with a siding.
1. Prepare the facade: save it from excess items. Eliminate anything that comes into contact with the wall and will prevent you from mounting. It can be bushes, trees, drainpipes, lantern fasteners and so on.
The lining is needed in all areas of the siding installation. Including, around the windows, around the doors, at the corners.
2. Between the boards, the distance is about 40 cm. If there are strong winds in your region, then 20 cm. Nail or fasten the screws to the wall.
3. Planks reinforce vertically, if you chose the siding horizontal. And, accordingly, on the contrary. Although vertically the siding panels are installed extremely rarely.
4. Around the openings of doors and windows, use shorts perpendicular to the main grille.
So, siding is installed on the crate. It all begins with the installation of the starting strip. Arrange it horizontally along the entire perimeter of the building. Further, all joints can be overlapped. Here the H-profile is useful. And at the corners you need either an internal or a flashy corner.
5. After the auxiliary profiles, proceed with the installation of the main panels. Insert the lower edges of the following panels into the lock of the start bands. The upper edges nail to the wall( crate) nails of aluminum with wide hats.
The nails must be cut in the middle of the slots, the distance between the nails is from 200 to 500 cm. Depending on the winds in your area.
6. Try to position the panels without tension, directly. Let in the future they do not destroy.
The final profile is nailed before the final panel is installed. Therefore, the final panel is cut to the desired width and pushed into the final profile.
What you need to remember to properly cover the siding with a house?
1. Do not drive the nail until it stops. Between the nail head and the panel, leave 1 cm. The siding panels horizontally should move easily.
2. Do not drive nails from the front of the panel!
2. When you decide to make shutters, then make holes in the panels 5mm more than the mounting bolts.
