How to clean the hood in the kitchen and wash her fat?

Situated in the kitchen extractor fan performs air purification function, and timely cleaning of this unit is a necessary procedure. This will allow to maintain its performance and significantly extends the service life. Purification of the cooker hood from grease and other contaminants - is quite time-consuming and complicated process, but it is quite possible to carry out themselves. This device is subject to frequent pollution, and every owner of such a device must know how to clean up the hood and keep it in the proper form.

Methods for cleaning the filter

Particular difficulties arise when cleaning the filter, which is needed for better ventilation air flow. If contaminated filter hoods capacity and quality of air purification in the kitchen markedly reduced.

Before starting the purification filter cleaning means must first prepare and rags, as well as to evaluate the degree of its contamination. The most easy to clean new hood, which is enough to wash with warm water and cleaning agent.

When the filter medium is recommended contamination soak it briefly in hot detergent solution. After softening the contaminants carry out a thorough treatment of the surface.

If the result of the hand cleaning result has failed, to be filled with a suitable volume of water and soap container (better cleaning) with the addition of 2-3 tablespoons of soda. The obtained mixture is recommended to boil about 10 minutes, filter and leave it in a liquid for 2-3 hours. Processing should be carried out on each side, which will completely get rid of fatty plaque.

However, even such a thorough treatment of the filter does not always bring the desired effect. Sometimes require more effective cleaning methods.

Removing stubborn dirt

If it is impossible to clean the filter by congealed fat in a conventional manner, can be used for cleansing the gutters.

Before using a chemical product, wear rubber gloves. The stainless vessel (shell) is filled with water so that the filter was completely covered, and the cleaning agent is added. The filter is maintained in the solution for 15 minutes, then the fat coating is easily removed. Pre encouraged to read the instructions for use of the drug, as some substances can not be used in hot or cold water.

This technique allows you to effectively clean the surface of the ingrained fat, but there are some limitations to its use. To apply such processing may be infrequent, since in formulations contained alkali metal compound can ruin the filter elements.

The most lenient way to clean the filter from grease and dirt, is the use of the means used during rinsing of drain pipes, whose value is within 250 rubles.

The algorithm is:

• prepared filter is placed on a baking tray;
• It is poured over it cleanser (most often, these formulations are produced in granular form);
• prepared mass is poured boiling water, the reaction which causes a violent chemical reaction;
• while maintaining the solution should be 10 minutes, used with caution liquid is discharged into the toilet;
• in the final stage of the filter mesh is washed and dried;
• work should be carried out in rubber gloves, goggles and a respirator.

Launder itself hood

After finishing work with dirty filters need cleaning most of the fat extraction. For this purpose, special cleaners for processing surfaces made of stainless steel.

In the absence of such solutions to brush hood can use improvised means, mixing teaspoon any liquid used for washing dishes, with one liter of hot water. the entire surface of the contaminated extraction solution it is processed.

helpful hints

All necessary equipment installation must be done by qualified personnel who have the necessary access to this work. From this condition term use hoods depend.

Conduct extraction cleaning is allowed only when it is completely disconnected from the mains!

During washing and drying the exhaust gas or electric stove should be kept off. A direct hit fire or heating may cause a fire and melt plastic elements disposed on the exhaust side. Purification of the filter is recommended to perform 1 time in 2 months.