How to put a laminate on a parquet

click fraud protection

How to put a laminate on a parquet photo To give the interior of the room a finished look, laminate is successfully applied. Due to the richness of his palette, you can select the material that will exactly match the design idea. In addition, this coating is an additional insulation of any gender. You can put the laminate on the floor, and how, you will tell our site.

To put the laminate on the flooring you will need:
- jigsaw;
- measuring tape;
- hammer;
- a pencil;
- square;
- wood hacksaw;
- padding block.

1 Soak the laminate in the room where the styling will take place, about two days. It is necessary that it be adapted to the humidity and temperature of the room. Prepare the tools for laying the laminate. Usually they are: a jigsaw, a tape measure, a hammer, a pencil, a square, a hacksaw for wood, a padding bar.

2 Prepare the surface of the parquet. Assess the horizontal nature of the base for the laminate. If there are irregularities, align them with a grinder. Check the hardness of the coating. In the event that the boards sink under the weight of a person, they should be replaced or strengthened. In order to be absolutely sure of the horizontal nature of the coating, apply a self-leveling screed on it.

Instruments
 Widget from SocialMart

3 Place the polyethylene film perpendicular to the direction that will be used when laying the laminate. Then put the substrate. The best option is a cork, becauseit is made of environmentally friendly materials, but foam polyethylene of different thicknesses can also be used.

4 Lay the laminate on the surface of the old parquet. The correct way is to lay along the line of sunlight. This is due to the fact that the joints of the panels will not be visible.
Laminate is divided into two types: globular( lock) and glue. The first has either lock-locks( Lock), or collapsible locks( Click).The main superiority of the latter is the strength of the joint. Lock-locks, in turn, are cheaper, having a lower quality of adhesion. The lock type of the laminate is laid by inserting the stud of one panel into the groove of the other.

5 Lay the laminate in a "brick" way, i. E.the ranks must communicate with each other. Set the first row. If the last panel is longer than necessary, cut it, taking into account that there should be a gap between it and the wall about 3-5 mm. Start the second row with the cut off part. Remember, it should not be shorter than 20 cm. Similarly, make the entire installation.

instagram viewer