Video repair of apartments, repair instructions. Decorating with plastic panels of walls and ceiling with your own hands with video lessons.
At the moment, this type of finishing is one of the most economical. Also, plating with plastic panels is used to level the walls or ceiling. Decorating with plastic wall panels is suitable for any premises, and the video will help to understand. Plastic does not need special care, the surfaces lined with plastic, you just need to wipe with a damp cloth from time to time.
Before starting work, you need to determine the color and quantity of the material. Make all room measurements and, based on the fact that the panels have a size of 0.5 m * 3 m, calculate the required quantity. Panels come in other sizes, so it is recommended to go to the store where you will buy materials, and to specify all sizes. The number of docking profiles( moldings) should also be calculated in advance. All necessary materials should be taken with a small margin.
Panels are attached to a wooden crate. Therefore, you must first decide how the panels will be located - vertically or horizontally. If vertical, the wooden bars are attached to the wall vertically in 0.5 m increments. Then they are fixed with horizontal bars( 3 pcs.).If horizontally, then the bottom bars horizontally in steps of 0.4 m. We measure the elements of the crate and calculate the desired number. Reiki is better to buy a length no less than the height( or length) of the wall. The suitable cross-section of the bars is 4 cm * 2 cm or 6 cm * 4 cm. The wooden frame is mounted to the wall using dowels and self-tapping screws or with nails. Each element must be checked by the building level, especially if the walls are very crooked. Finishing plastic panels with their own hands hides irregularities, but you need to put bars for this purpose evenly.
We set the starting molding, if not applied ceiling, in the upper and lower part of the wall. Then the corner, outer or inner, depending on where the lining is from. After installing all the profiles, we begin installing the panels. Slightly bending, the panel is inserted into the starting profiles, and then to the stop in the corner. It is necessary to check the level set by the canvas. Mount the panels with metal holders. After installing the blade, the holder is inserted into the edge of the panel and nailed to the wooden frame. You can also use brackets or screws for fastening. Thus, all panels are installed to the corner. In the corner again install the angle profile, etc.
When facing the kitchen, the installation should be conducted with a small gap between the panels, because the temperature regime in the kitchen is not stable. And with a significant temperature increase, the plastic will expand. And now watch the video and fix the material.
Video trim with plastic panels
Stay tuned for updates on our website to repair the apartment yourself.
Author Kurochkina Svetlana Sergeevna
